Vetter Mini Lifting bags 8 bar (116 psi) Manuel d'utilisateur télécharger pdf (Page 8)

Vetter Mini-Lifting Bags 8.0 bar

Page 7/19

In case the lifting height of an Mini-Lifting Bag is not sucient

then a maximum of 2 bags can be placed over each other. In this

mode, the lifting height is additive for both Mini-Lifting Bags.

However the lifting power only corresponds to that of the smaller

bag. Basically, the lower bag should always be inated rst.

Sequence: large bag below,

small bag on top!

Never place 3 or more bags over each other!

A Mini-Lifting Bag under load can be compared to a spring under

tension with respect to its behavour. As soon as the Mini-Lifting

Bag is suddenly released, e.g. by slipping, load break or anything

similar then there will be spontaneous catapulting outwards of

the Mini-Lifting Bag.

Never stand in front of the Mini-Lifting Bag!

This is an area of danger!

2.5 Correct handling and usage

The Mini-Lifting Bag is primarily a pneumatic rescue device used

by the rescue services (e.g. re services) with which trapped peo-

ple can be freed, access gained for rescue and many other tasks.

The Mini-Lifting Bag can also be used as a working device in order

to lift or move loads.

Mini-Lifting Bags are subject to national requirements of the re

service sector. Further instruction information can be obtained

from the operating instructions of the user. The complete Mini-

Lifting Bags system is cold-resistant to -20 °C and heat-resistant

up to +55 °C.

2.6 Safety instructions

Pre-specied personal protective clothing is to be worn during

operation! For example: protective clothing, helmet, protective

gloves, protection for eyes and face, noise protection etc.

The national regulations in connection with lifting bag systems

and their use are to be observed. For example: DIN EN 13731,

national regulations. The Mini-Lifting Bags are only to be used

with compressed air, under no circumstances are they to be used

with inammable gases or aggressively acting gases. Vetter Mini-

Lifting Bags are only to be inated with original Vetter ination

ttings because these were subjected to an acceptance test by

the manufacturer. The lifting bag system is to be tested for perfect

condition before and after use (specications from the manufac-

turer, national regulations).

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 19 20

Pas de commentaire

Vetter Mini Lifting bags 8 bar (116 psi) Manuel d'utilisateur Page 8